Rheem Select 5 Ton 14.3 SEER2 Heat Pump Condenser

The WP14AY60AJ2NA is a Rheem Select 5 ton heat pump condenser engineered to provide efficient cooling and heating for compatible residential HVAC systems. This outdoor unit uses R-454B refrigerant and features a two-stage scroll compressor for improved comfort and more responsive operation.

Unlike a straight-cool air conditioner condenser, this heat pump can reverse the refrigerant cycle. During summer, it transfers indoor heat outdoors. During cooler weather, it collects available outdoor heat and transfers it into the home. A compatible air handler and optional electric heat kit may be required to create a complete system.

WP14AY60AJ2NA Features and Benefits

The WP14AY60AJ2NA includes features designed to support year-round comfort, efficient heat transfer, outdoor equipment protection, and convenient professional service.

• Nominal 5 ton heat pump capacity
• Provides both cooling and heating
• 14.3 SEER2 cooling efficiency with qualifying equipment
• Designed specifically for R-454B refrigerant
• Two-stage scroll compressor
• High and low operating stages
• Improved temperature and humidity control
• Inverted refrigerant reversing valve
• Optimized 7 mm condenser coil design
• Fully louvered steel outdoor cabinet
• Expanded service-valve working area
• Accessible electrical control box
• Compatible with standard 24-volt thermostats
• Compatible with required refrigerant detection components

WP14AY60AJ2NA Product Specifications

The WP14AY60AJ2NA must be paired with approved indoor equipment to achieve its published heating, cooling, and efficiency ratings. Actual performance depends on the air handler, indoor coil, heat kit, blower airflow, ductwork, installation conditions, and applicable AHRI-certified combination.

• Manufacturer: Rheem
• Series: Endeavor Line Select
• Model: WP14AY60AJ2NA
• Equipment type: Split-system heat pump
• Operating modes: Cooling and heating
• Nominal capacity: 5 tons
• Nominal capacity designation: 60,000 BTU
• Rated total cooling capacity: Approximately 54,000 BTU
• Heating capacity at 47°F: Approximately 54,000 BTU
• Heating capacity at 17°F: Approximately 32,000 BTU
• Cooling efficiency: 14.3 SEER2
• EER2: Approximately 9.0
• HSPF2: Approximately 7.5
• Refrigerant: R-454B
• Factory refrigerant charge: Approximately 194 ounces
• Compressor: Two-stage scroll compressor
• Voltage: 208/230 volts
• Phase: Single phase
• Frequency: 60 Hz
• Minimum circuit ampacity: 33 amps
• Maximum overcurrent protection: 50 amps
• Liquid-line connection: 3/8 inch
• Suction-line connection: 7/8 inch
• Sound rating: Approximately 74 dB
• Dimensions: Approximately 39.17 inches high × 35.55 inches wide × 35.55 inches deep
• Operating weight: Approximately 253 pounds
• Shipping weight: Approximately 303 pounds

Two-Stage Heating and Cooling

The two-stage compressor can operate at a lower stage when the property requires moderate heating or cooling and switch to the higher stage when demand increases. This allows the system to adjust its output more effectively than a basic single-stage heat pump.

Longer operation at the lower stage may support more consistent indoor temperatures, improved humidity control during cooling, and reduced equipment cycling. Final performance depends on correct equipment matching, thermostat configuration, airflow, and professional commissioning.

R-454B Refrigerant Technology

The WP14AY60AJ2NA is engineered specifically for R-454B refrigerant. It must only be paired with indoor equipment designed and approved for the same refrigerant. Components intended exclusively for R-410A or R-32 systems should not be connected unless Rheem expressly approves the combination.

R-454B is classified as an A2L refrigerant. Installation and service must follow applicable codes and Rheem instructions. The required refrigerant detection sensor and mitigation board are installed in compatible indoor equipment as part of the complete system.

Heating Performance in Cold Weather

A heat pump transfers available outdoor heat instead of generating all heating through electric resistance. However, heating capacity naturally decreases as outdoor temperatures fall. This model provides approximately 32,000 BTU of heating capacity at 17°F under its published test conditions.

A properly sized electric heat kit may provide supplemental or emergency heating during colder weather. Heat-kit capacity, electrical requirements, air-handler compatibility, and local climate conditions must be evaluated by an HVAC professional.

System Compatibility

Before purchasing the WP14AY60AJ2NA, verify the building’s load requirements, electrical service, air handler, heat kit, refrigerant type, line-set dimensions, airflow, thermostat, and AHRI system combination. Nominal tonnage alone does not guarantee component compatibility.

Professional Installation Required

Professional installation of the WP14AY60AJ2NA by a qualified HVAC technician is required. Proper placement, electrical protection, brazing, evacuation, refrigerant charging, airflow adjustment, thermostat setup, and system testing are essential for safe and dependable operation.

Explore more heat pump condensers from Xpress Supply or review the official Rheem WP14AY60AJ2NA specifications.

Warranty and Documentation

Eligible Rheem equipment may qualify for a 10-Year Conditional Parts Limited Warranty when registered online within 90 days of installation. Without registration, the base limited warranty is 5 years. Coverage periods, exclusions, and legal conditions may vary according to the application and installation location. Review the complete manufacturer warranty before purchase and register the WP14AY60AJ2NA after installation.

Coverage terms for the WP14AY60AJ2NA are detailed in the official Rheem residential split limited warranty.

After installation, eligible equipment can be registered through the official Rheem warranty and registration portal.