Rheem Select 5 Ton 24.5″ Electric HVAC System with Heat Kit – Up to 15.2 SEER2

Rheem Select 5 Ton 24.5 Inch Electric HVAC System

The Rheem Select 5 Ton 24.5 Inch Electric HVAC System combines high-capacity cooling, flexible indoor airflow and powerful supplemental electric heating. This complete configuration includes a Rheem Select outdoor air conditioner, a 24.5-inch multiposition air handler and a compatible 20 kW electric heat kit.

The system uses R-454B refrigerant and can achieve cooling efficiency ratings up to 15.2 SEER2 with an approved matched equipment combination. Its approximately 60,000 BTUs of nominal capacity make it suitable for properties with a professionally calculated 5-ton cooling requirement.

What Is Included with the Rheem Select 5 Ton 24.5 Inch Electric System?

The Rheem Select 5 Ton 24.5 Inch Electric system includes three primary components:

• Rheem WA14AY60AJ1NA air conditioner: A 5-ton outdoor condenser featuring single-stage cooling, a scroll compressor and R-454B refrigerant.
• Rheem WH2TY6024STANNJ air handler: A multiposition 5-ton indoor unit with a 24.5-inch-wide cabinet, constant-torque motor, two-stage airflow and aluminum N-coil.
• PROTECH RXBH-24A20J-B heat kit: A 20 kW electric heater kit designed for compatible 24.5-inch Rheem air handlers and 208–240 volt applications.

The selected components must be properly matched and configured. Final efficiency and comfort depend on professional installation, airflow settings, electrical service and the property’s duct system.

Benefits of the 24.5 Inch Air Handler

The Rheem Select 5 Ton 24.5 Inch Electric HVAC System uses the WH2TY6024STANNJ air handler, which measures 24.5 inches wide, 21 11/16 inches deep and 55.5 inches high. This wider cabinet provides a different indoor coil and airflow configuration from the 21-inch version.

The four-way convertible cabinet supports upflow, downflow, horizontal-left and horizontal-right installations. This flexibility allows a qualified installer to configure the indoor unit according to the available equipment space, duct layout and required service clearances.

Key System Features

• Nominal 5-ton or 60,000 BTU cooling capacity
• Efficiency ratings up to 15.2 SEER2
• Lower-GWP R-454B refrigerant
• Single-stage scroll compressor
• 24.5-inch-wide indoor air handler
• Four-way multiposition configuration
• Constant-torque blower motor
• Two-stage indoor airflow
• Aluminum indoor N-coil
• 20 kW supplemental electric heating

High-Capacity Residential Cooling

The outdoor condenser included with the Rheem Select 5 Ton 24.5 Inch Electric system belongs to Rheem’s Endeavor Line Select Series. Its single-stage scroll compressor delivers consistent cooling output during warm weather. The fully louvered steel cabinet helps protect the outdoor coil against weather, debris and common yard hazards.

The condenser incorporates an optimized coil design that supports effective airflow and heat transfer. Accessible service areas also help qualified HVAC technicians perform installation, inspections and future maintenance.

Review the outdoor unit’s specifications on the official Rheem condenser page.

Indoor Airflow and Multiposition Installation

The WH2TY6024STANNJ air handler uses a constant-torque motor with two stages of airflow. Rheem lists approximately 1,200 CFM at the lower airflow setting and 1,600 CFM at the higher setting. Final airflow must be adjusted according to the approved equipment match, duct system and installation requirements.

The cabinet contains one inch of foil-faced insulation to support quieter operation. Its aluminum indoor N-coil is designed for corrosion resistance, while the rugged cabinet construction provides strength and installation flexibility.

Review the air handler’s specifications on the official Rheem air handler page.

20 kW Supplemental Electric Heating

The Rheem Select 5 Ton 24.5 Inch Electric HVAC System uses a 20 kW electric heat kit instead of a gas furnace. Electric resistance elements warm the air inside the air handler before the blower distributes it throughout the property.

A 20 kW heat kit requires significant electrical capacity. A qualified professional must confirm the panel capacity, voltage, wiring, circuit protection and applicable electrical codes before installation. The correct heater size should also be based on the property’s heating load and regional climate.

Is a 5 Ton System the Correct Size?

A 5-ton HVAC system should only be selected after evaluating the property’s cooling requirements. Square footage provides a general estimate, but insulation, ceiling height, windows, climate, sun exposure, occupancy, ductwork and air leakage can substantially affect the required capacity.

An oversized system may cycle too frequently and provide inadequate humidity control. An undersized system may run continuously without maintaining the desired indoor temperature. Use the Xpress AC Sizing Calculator as a starting point and request a professional Manual J load calculation before purchasing.

Professional Installation Required

The Rheem Select 5 Ton 24.5 Inch Electric system must be installed by a qualified HVAC professional familiar with R-454B equipment and applicable A2L refrigerant procedures. The installer must verify refrigerant piping, electrical service, airflow settings, duct capacity, condensate drainage and local code requirements.

A compatible thermostat, refrigerant line set, condenser pad, disconnect, drain pan, electrical wiring and other installation materials may be required. These accessories are not included unless specifically identified in the selected package.

Why Buy This System from Xpress Supply?

When you purchase the Rheem Select 5 Ton 24.5 Inch Electric HVAC System from Xpress Supply, you receive genuine equipment, competitive pricing and support verifying component compatibility. Our HVAC product team can also help identify additional installation supplies before shipment.

Browse our selection of electric HVAC systems or contact Xpress Supply for assistance selecting the correct system configuration.

Frequently Asked Questions

How is this system different from the 21-inch version?

This version uses the WH2TY6024STANNJ air handler with a 24.5-inch-wide cabinet and an aluminum N-coil. The other version uses a 21-inch-wide air handler with a different coil and airflow configuration.

Does this system provide both cooling and heating?

Yes. The outdoor air conditioner supplies cooling and the 20 kW electric heat kit provides supplemental heating.

Is the outdoor condenser a heat pump?

No. The WA14AY60AJ1NA is a straight-cool air conditioner. Heating comes from the electric heat kit installed inside the air handler.

Does this system always achieve 15.2 SEER2?

The Rheem series offers efficiency ratings up to 15.2 SEER2. The final certified rating depends on the exact indoor and outdoor equipment combination and installation conditions.

Can this equipment be installed without an HVAC contractor?

No. Professional installation is required for safe refrigerant handling, correct electrical connections, proper airflow and compliance with manufacturer instructions and local regulations.